新闻页banner

Welcome to SMAD LTD.    |    Refrigerators,Chest Freezer,Washing Machine,Washers,Dryers,Dishwashers,Becerage Cooler,Microwave Oven,Water Dispenser,Wine Cooler,Air Conditioner   Français    |    Refrigerators,Chest Freezer,Washing Machine,Washers,Dryers,Dishwashers,Becerage Cooler,Microwave Oven,Water Dispenser,Wine Cooler,Air Conditioner   Español

Refrigerators,Chest Freezer,Washing Machine,Washers,Dryers,Dishwashers,Becerage Cooler,Microwave Oven,Water Dispenser,Wine Cooler,Air Conditioner

Refrigerators,Chest Freezer,Washing Machines,Washers,Dryers,Dishwashers,Microwave Oven,Water Dispenser,Wine Cooler,Air Conditioner

NEWS

Why do the two flat prongs on the plugs for electrical appliances have holes in them?

Writer:Mr LeftySource:www.smad.com.cn Number of visits: Date:2014.10.20

If you unplug any appliance in your house, there's a 98 percent chance than the two flat prongs have holes in them.

www.smad.com.cn

There are three reasons for the holes:

  • If you were to take apart an outlet and look at the contact wipers that the prongs slide into, you would find that they have havebumps on them. These bumps fit into the holes so that the outlet cangrip the plug's prongs more firmly. This detenting prevents the plug from slipping out of the socket due to the weight of the plug and cord. It also improves the contact between the plug and the outlet.
  • Electrical devices can be "factory-sealed" or "locked-out" by the manufacturer or owner using a plastic tie or a small padlock that runs through one or both of the prong holes. Construction projects or industrial safety requirements may require this type of sealing. For example, a manufacturer might apply a plastic band through the hole and attach it to a tag that says, "You must do blah blah blah before plugging in this device." The user cannot plug in the device without removing the tag, so the user is sure to see the instructions.
  • There also is a small savings in raw materials (metal) for the manufacturer of the actual plug prong. Every little bit helps!

It has been reported that really old outlets used captive ball bearings and coil springs for the detent, but today it is done with a bump and springy copper contacts.

                                                          By smad ltd.Network operations team

      Website:http://www.smad.com.cn

TypeInfo: Industry News

Keywords for the information:household appliances 

Download annexCompany Introduction Product product detail